Danfoss VLT AQUA Drive FC 202

8.1.10 Wiring for Regeneration
Table 67: Wiring Configuration for Regeneration
Parameters
+24 V
+24 V
D IN
D IN
D IN
COM
D IN
D IN
D IN
D IN
+10
V
A IN
A IN
COM
A OUT
COM
XD2.10
XD2.11
XD2.12
XD2.13
XD2.18
XD2.14
XD2.15
XD2.16
XD2.17
XD2.19
XD2.6
XD2.7
XD2.8
XD2.9
XD2.5
XD2.4
e30bu091.10
Function Setting
Parameter 1-90 Motor Thermal Protection 100%*
* = Default value
To disable regeneration, decrease parameter 1-90 Motor Thermal Protection to 0%. However, if the
application uses motor brake power and regeneration is not enabled, the drive will trip.
Wiring Configuration Examples
Operating Guide | VLT® AQUA Drive FC 202
AQ262141056213en-000101 / 130R0882 | 121
Danfoss A/S © 2018.10