Term Definition
PID Proportional integral derivative
PLC Programmable logic controller
P/N Part number
PROM Programmable read-only memory
PS Power section
PTC Positive temperature coefficient
PWM Pulse width modulation
R
S
Stator resistance
RAM Random-access memory
RCD Residual current device
Regen Regenerative terminals
RFI Radio frequency interference
RMS Root means square (cyclically alternating electric current)
RPM Revolutions per minute
SCR Silicon controlled rectifier
SMPS Switch mode power supply
S/N Serial number
STO Safe Torque Off
T
LIM
Torque limit
U
M,N
Nominal motor voltage
V Volt
VVC Voltage vector control
X
h
Motor main reactance
11.3 International/North American Default Parameter Settings
Setting parameter 0-03 Regional Settings to [0] International or [1] North America changes the default settings for some parameters.
Table 10.2 lists the parameters that are affected.
Table 117: VLT
®
FC Series International/North American Default Parameter Settings
Parameter International default value North American default value
Parameter 0-03 Regional Settings International North America
Parameter 0-71 Date Format DD-MM-YYYY MM/DD/YYYY
Parameter 0-72 Time Format 24 h 12 h
Parameter 1-23 Motor Frequency 50 Hz 60 Hz
Parameter 1-25 Motor Nominal Speed 1400 RPM 1680 RPM
Appendix
Operating Guide | VLT® AQUA Drive FC 202
AQ262141056213en-000101 / 130R0882 | 193
Danfoss A/S © 2018.10
To Next Page
Loading...
Need help?
General