5.16 MCCB Configuration 97
5.17 Safe Torque Off (STO) Wiring 98
6 Pre-start Check List 99
7 Commissioning 101
7.1 Applying Power to the Drive 101
7.2 Programming the Drive 101
7.2.1 Parameter Overview 101
7.2.2 Parameter Navigation 102
7.2.3 Programming Example for an Open-loop Application 102
7.2.4 Entering System Information 103
7.2.5 Configuring Automatic Energy Optimization 104
7.2.6 Configuring Automatic Motor Adaptation 105
7.3 Testing Before System Start-up 105
7.3.1 Testing Motor Rotation 105
7.3.2 Testing Encoder Rotation 106
7.4 Starting Up the Drive for the First Time 106
7.5 Parameter Settings 106
7.5.1 Parameter Setting Overview 106
7.5.2 Uploading and Downloading Parameter Settings 107
7.5.3 Restoring Factory Default Settings Using the Recommended Initialization 107
7.5.4 Restoring Factory Default Settings Using Manual Initialization 108
8 Wiring Configuration Examples 109
8.1 Application Examples 109
8.1.1 Wiring Configuration for Automatic Motor Adaptation (AMA) 109
8.1.2 Wiring Configuration for Automatic Motor Adaptation (AMA) without T27 110
8.1.3 Wiring Configuration: Speed 110
8.1.4 Wiring Configuration: Feedback 113
8.1.5 Wiring Configuration: Run/Stop 115
8.1.6 Wiring Configuration: Start/Stop 117
8.1.7 Wiring Configuration: External Alarm Reset 119
8.1.8 Wiring Configuration: RS485 120
8.1.9 Wiring Configuration: Motor Thermistor 120
8.1.10 Wiring for Regeneration 121
8.1.11 Wiring Configuration for a Relay Set-up with Smart Logic Control 122
8.1.12 Wiring Configuration for a Submersible Pump 122
8.1.13 Wiring Configuration for a Cascade Controller 125
8.1.14 Wiring Configuration for a Fixed Variable Speed Pump 127
8.1.15 Wiring Configuration for Lead Pump Alternation 128
Contents
Operating Guide | VLT® AQUA Drive FC 202
AQ262141056213en-000101 / 130R0882 | 5Danfoss A/S © 2018.10
To Next Page
Loading...
Need help?
General