Datalogic Gryphon 2D Series - Label ID Symbology Selection

Enter/Exit Programming Mode Label ID
98 Gryphon™ I GD/GBT/GM4500
Label ID Symbology Selection
This option selects the symbology for which a Label ID is to be configured. See
"Label ID: Set Individually Per Symbology" on
page 290
CANCEL
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Set UPC-A Label ID Character(s)
Set UPC-A/P2 Label ID Character(s)
Set UPC-A/P5 Label ID Character(s)
Set UPC-E Label ID Character(s)
Set UPC-E/P2 Label ID Character(s)
Set UPC-E/P5 Label ID Character(s)
for full instructions.
~
$CABID
$CA2ID
$CA5ID
$CEBID
$CE2ID
$CE5ID