Scanning Features
Product Reference Guide
123
Motion Still Timeout
Motion Still Timeout specifies the waiting time after which no motions is
detected. When no motion is detected for period of time longer than the set
Motion Still Timeout period, the scanner assumes it is in a motionless condi-
tion. The selectable setting are from 500 to 25,500 milliseconds in 100 milli-
second increments. The default is 2 seconds. This option relates
to such
features and the Aimer On timing and Stand Mode Object Sense scanning with
respect to motion.
Select Motion Still Timeout Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at l
eft followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). End by scanning the
ENTE
R/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
14 = Motion Still Timeout for 2 seconds
To Next Page
Loading...
Need help?
General
