Enter/Exit Programming Mode Batch Features
256 Gryphon™ I GD/GBT/GM4500
Copy Configuration to Base Station
Scan the following label to copy the current scanner configuration to the Base Sta-
tion. Use this method when the Auto Configura
tion Update feature is disabled and
you want a one-time configuration update to be performed on the Base Station.
Copy Configuration to Base Station
NOTE
Do not scan an ENTER/EXIT PROGRAMMING MODE label with this bar
code
.
Batch Features
Batch Mode
This option specifies whether to store labels in the handheld while discon-
nected from the base. Options are as follows:
• Disabled — The handheld will not store/batch labels.
• Automatic — The handheld will store labels to RAM when the handheld
go
es out of range and is disconnected from the remote device.
• Manual — The handheld will always store labels to Flash memory. The user
must
manually send the stored labels to the remote device using a special
"batch send" label.
Batch Mode = Disabled
Batch Mode = Automatic
Batch Mode = Manual