Enter/Exit Programming Mode Code 93
208 Gryphon™ I GD/GBT/GM4500
Code 93 Set Length 1
This feature specifies one of the bar code lengths for Code 93 Length Control
on page 207
. Length 1 is the minimum label length if in Variable Length on
page 207
Mode, or the first fixed length if in Fixed Length on page 207 Mode.
Length includes the bar code’s data characters only.
The length can be set from 01 to 50 characters. See
"Set Length 1" on
page 302
for more detailed programming in
structions.
Select Code 93 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
01 = Length 1 is 1 Character