1D Symbologies Enter/Exit Programming Mode
Product Reference Guide 193
Standard 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for Standard 2 of 5 Length
Control on page 191
. Length 2 is the maximum label length if in Variable
Length on page 191
Mode, or the second fixed l
ength if in
Fixed Length on
page 191
Mode. Length includes the bar code’s check an
d data characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See
"Set Length 2" on
page 303 for
more detailed progr
amming instructions.
$CS2L2
Select Standard 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
To Next Page
Loading...
Need help?
General
