Datalogic Gryphon 2D Series Product Reference Guide

Enter/Exit Programming Mode Datalogic 2 of 5
176 Gryphon™ I GD/GBT/GM4500
Datalogic 2 of 5 Length Control
This feature specifies either variable length decoding or fixed length decoding
for the Datalogic 2 of 5 symbology.
Variable Length: For variable length decoding, a minimum and maximum length
may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
Datalogic 2 of 5 Length Control = Variable Length
Datalogic 2 of 5 Length Control = Fixed Length
Datalogic 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for Datalogic 2 of 5 Length
Control on page 176
. Length 1 is the minimum label length if in Variable Length
on page 171
Mode, or the first fixed length if in Fixed Length on page 171
Mode. The length includes the bar
code’s data characters only.
The length can be set from 2 to 50 characters in increments of two. See
"Set
Length 1"
on
page 302 for more detailed programming instructions.
$CD2L1
Select Datalogic 2 of 5 Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
06 = Length 1 is 6 Characters

Datalogic Gryphon 2D Series Specifications

General

Brand	Datalogic
Model	Gryphon 2D Series
Category	Barcode Reader
Language	English