Datalogic Gryphon 2D Series Product Reference Guide

Enter/Exit Programming Mode Code 128
166 Gryphon™ I GD/GBT/GM4500
Code 128 Length Control
This feature specifies either variable length decoding or fixed length decoding
for the Code 128 symbology.
Variable Length: For variable length decoding, a minimum and maximum length
may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
Code 128 Length Control = Variable Length
Code 128 Length Control = Fixed Length
Code 128 Set Length 1
This feature specifies one of the bar code lengths for Code 128 Length Control
on page 166
. Length 1 is the minimum label length if in Variable Length on
page 166
Mode, or the first fixed length if in Fixed Length on page 166 Mode.
Length includes the bar code’
s data characters only.
The length can be set from 1 to 80 characters. See
"Set Length 1" on
page 302
for more detailed programming in
structions.
Select Code 128 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
01 = Length 1 is 1 Character
$CC8LC00
$CC8LC01

Datalogic Gryphon 2D Series Specifications

General

Brand	Datalogic
Model	Gryphon 2D Series
Category	Barcode Reader
Language	English