EasyManuals Logo

Datalogic Gryphon 2D Series Product Reference Guide

Datalogic Gryphon 2D Series
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #187 background imageLoading...
Page #187 background image
1D Symbologies Enter/Exit Programming Mode
Product Reference Guide 177
Datalogic 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for Datalogic 2 of 5 Length
Control on page 176
. Length 2 is the maximum label length if in Variable
Length on page 171
Mode, or the second fixed l
ength if in
Fixed Length on
page 171
Mode. The length includes the bar
code’s data characters only.
The length can be set from 2 to 50 characters. A setting of 00 specifies to
ig
nore this length (only one fixed length). See
"Set Length 2" on
page 303 for
more detailed progr
amming instructions.
Select Datalogic 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
$CD2L2
~

Table of Contents

Other manuals for Datalogic Gryphon 2D Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic Gryphon 2D Series and is the answer not in the manual?

Datalogic Gryphon 2D Series Specifications

General IconGeneral
BrandDatalogic
ModelGryphon 2D Series
CategoryBarcode Reader
LanguageEnglish

Related product manuals