Product Reference Guide 37
Chapter 3
Configuration Using Bar Codes
This and following sections provide programming bar codes to configure your
scanner by changing the default settings. For details about additional methods
of programming, see "
Customizing Configuration Settings" on page 34
.
NOTE
You must first enable your scanner to rea
d bar codes in order to
use this section. If you have not done this, go to
Setup, starting on
page 9
and complete the appropriate procedure.
Configuration Parameters
Once the scanner is set up, you can change the default parameters to meet your
application needs. Refer to "
Resetting the Product Configuration to Defaults" on page
35
for initial configuration in order to set the default values and select the
interface for your application.
The following configuration parameters are divided into logical groups, making
it
easy to find the desired function based on its reference group.
Interface Configuration:
• "RS-232 ONLY Interface" on page 41
• "RS-232/USB-COM Interfaces" on page 45
• "Keyboard Interface" on page 55
• "USB-OEM Interface" on page 87
Parameters common to all interface applications:
• "
Global Prefix/Suffix" on page 76
• "
Data Format" on page 93
offers advanced configuration options for custom-
ization of scanned data output.
• "
Reading Parameters" on page 105
control various operating modes and indi-
cators status functioning.
Symbology-specific parameters:
"1D Symbologies" on page 113
defines options for all symbologies and provides
the programming bar codes necessary for configuring these features.
NOTE
You must first enable your scanner to read bar codes in order to
use this section. If you have not done this, go to
Setup, starting on
page 9
and complete the appropriate procedure.
To Next Page
Loading...
Need help?
General
