Enter/Exit Programming Mode Enable Character
54 Gryphon™ I GD/GBT/GM4500
Enable Character
Specifies the value of the RS-232 host command used to enable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
"Enable
Character"
on
page 281 for more detailed programming instructions
NOTE
Select Enable Character Setting
DEFAULT
0x45 = Enable Character is ‘E’
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
Setting to previously defined characters such as XON, XOFF, or host commands con-
flicts with normal operation of
these characters.
.
$CR2EC
~
To Next Page
Loading...
Need help?
General
