Enter/Exit Programming Mode Code 11
188 Gryphon™ I GD/GBT/GM4500
Code 11 Set Length 1
This feature specifies one of the bar code lengths for Code 11 Length Control
on page 187
. Length 1 is the minimum label length if in Variable Length on
page 187
Mode, or the first fixed length if in Fixed Length on page 187 Mode.
Length includes the bar code’s
check and data characters.
The length can be set from 2 to 50 characters. See
"Set Length 1" on page 302
for more detailed programming in
structions.
Select Code 11 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
04 = Length 1 is 4 Characters
$CC1L1
~
To Next Page
Loading...
Need help?
General
