Power Off
Product Reference Guide 29
Link Scanner as HID device to a Bluetooth host
Use this procedure to send data to a Bluetooth host using the Bluetooth HID
profile.
1. If using a Bluetooth adapter on the host
device, install any driver provided
with the adapter.
2. Scan the Link to Host in HID mode label below to make the scanner visible
to
the host device.
3. Use the Bluetooth manager of the host device to "Discover new devices"
a
nd select "GBT4500 …". If you receive an error message, it may be neces-
sary to change the security settings on either the host device or the scan-
ner.
4. On the host device, open the program that is meant to receive the incom-
ing data.
The data transmitted by the sca
nner will appear in the program as if it was
typed using the keyboard of the host device.
Link to Host in HID mode
NOTE
The Gryphon I GBT4500 can be set up t
o authenticate the remote system
when connecting, by entering a Bluetooth passkey or a PIN code. If you want
to set the security level and authentication options suitable for your appli-
cation, or when adding new equipment to a system that requires authenti-
cation or uses a custom security PIN
, please see the PRG for information.
Power Off
Scan the bar code below to shut off power to the handheld until the next trigger
pull.
PowerOff
To Next Page
Loading...
Need help?
General
