Datalogic Gryphon 2D Series Product Reference Guide

Enter/Exit Programming Mode BT Security Features
262 Gryphon™ I GD/GBT/GM4500
BT Security Features
On the BT system, it is possible to set a (configurable) PIN code to authenticate/
connect BT devices, and encrypt the data.
The BT PIN code can be enabled and configured
by reading the bar codes in the
following sections.
NOTE
If you are using a BT scanner directly connected to a host through a BT dongle,
verify that the scanner and the BT driver used by the dongle share the same PIN
code and the same security level. Otherwise the connection cannot be established.
Follow these steps to set the PIN code for a scanner:
1. Enable BT Security Mode by scanning the “Enable”
bar code below.
2.
Sel
ect a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in
"Select PIN Code Length" on pa
ge 244.
3. Scan the relevant bar code from
"Set PIN Code" on page 244, then scan the
desired alphanumeric characte
rs from the keypad in
Appendix D, Keypad
to set the PIN code.
See
page 301 in “References” for more detailed information and examples for
this feature.
BT Security Mode
This feature enables/disables authentication and encryption of the BT link. Use
the feature
"BT PIN Code" on
page 244 to specify the length and digits in the
PIN code used to authenticate the BT Link.
NOTE
DEFAULT
BT Security Mode = Disable
BT Security Mode = Enable
Changing the security mode setting will unlink the devices. If the Automatic Configuration Update
is set to the default “Enabled” setting, the devices must only be relinked. If the Automatic Config-
uration Update is set to “Disabled,” the Security M
ode setting must also be updated in the Base
Station using Aladdin. After the Base Station has been updated, the devices must be relinked.

Datalogic Gryphon 2D Series Specifications

General

Brand	Datalogic
Model	Gryphon 2D Series
Category	Barcode Reader
Language	English