Product Reference Guide 319
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for feature descriptions and programming bar codes for each
parameter. A column has also been provided for recording of your preferred default settings for
these same configurable features.
Table 30. Standard Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 39
USB Suspend Mode
Enable 39
RS-232 ONLY
Baud Rate
9600 41
Data Bits
8 Data Bits 42
Stop Bits
1 Stop Bit 43
Parity
None 43
Handshaking Control
RTS 44
RS-232/USB-COM
Intercharacter Delay
No Delay 46
Beep On ASCII BEL
Disable 47
Beep On Not on File
Enable 47
ACK NAK Options
Disable 48
ACK Character
‘ACK’ 49
NAK Character
‘NAK’ 49
ACK NAK Timeout Value
200 ms 50
ACK NAK Retry Count
3 Retries 51
ACK NAK Error Handling
Ignore Errors Detected 52
Indicate Transmission Failure
Enable 53
To Next Page
Loading...
Need help?
General
