Scanning Features
Product Reference Guide
121
Stand Mode Illumination Off Time
Specifies the amount of time reader illumination stays off after pulling the trig-
ger when in Stand Mode. The configurable range is 01 to 32 by 01 in incre-
ments of 500ms (500ms to 16 seconds). See
page 287
in “References” for a
description of this feature.
Select Stand Mode Time Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at l
eft followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments. See
page 288
in “References” for further description of
this feature.
Scanning Active Time = 3 seconds
Scanning Active Time = 5 seconds
DEFAULT
Scanning Active Time = 8 seconds
To Next Page
Loading...
Need help?
General
