Enter/Exit Programming Mode Standard 2 of 5
192 Gryphon™ I GD/GBT/GM4500
Standard 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for Standard 2 of 5 Length
Control on page 191
. Length 1 is the minimum label length if in Variable Length
on page 191
Mode, or the first fixed length if in Fixed Length on page 191
Mode. Length includes the bar cod
e’s check and data characters.
The length can be set from 1 to 50 characters. See
"Set Length 1" on page 302
for more detailed programming in
structions.
$CS2L1
Select Standard 2 of 5 Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
08 = Length 1 is 8 Characters
To Next Page
Loading...
Need help?
General
