RS-232/USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide 53
Indicate Transmission Failure
This option enables/disables the scanner’s ability to sound an error beep to
indicate a transmission failure while in ACK/NAK mode
Indicate Transmission Failure = Disable Indication
Indicate Transmission Failure = Enable Indication
DEFAULT
.
Disable Character
Specifies the value of the RS-232 host command used to disable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "Disable
Character"
on
page 280 for more detailed programming instructions.
NOTE
Select Disable Character Setting
DEFAULT
0x44 = Disable Character is ‘D’
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
$CR2TF00
$CR2TF01
~
To Next Page
Loading...
Need help?
General
