To Next Page

To Previous Page

1D Symbologies Enter/Exit Programming Mode

Product Reference Guide 185

ABC Codabar Dynamic Concatenation Timeout

This parameter specifies the timeout in 10-millisecond ticks used by the ABC

Codabar Dynamic Concatenation Mode. The timeout can be set within a range

of 05 to 255 in 10ms increments. A setting of zero specifies no delay.

Select ABC Codabar Dynamic Concatenation

Timeout Setting

To configure this feature, scan the ENTER/EXIT bar

code above, then the bar code at left followed by digits

from the Alphanumeric characters in

Appendix D,

Keypad

representing your desired character(s). End

by scanning the ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort and

not save the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

10 = Quiet Interval of 200 ms

ABC Codabar Force Concatenation

When ABC Codabar Concatenation is enabled and Force Concatenation is dis-

abled, both Codabar stand alone labels

and ABC Codabar concatenated labels

are transmitted. When ABC Codabar Concatenation is enabled and Force Con-

catenation is enabled only ABC Codabar

concatenated labels are transmitted

while Codabar stand alone labels are not transmitted.

Force Concatenation has no effect if the ABC Codabar Concatenation is dis-

abled. The Force Concatenation mode has eff

ect both in Static and Dynamic

Concatenation Modes.

DEFAULT

ABC Codabar Force Concatenation = Disable

ABC Codabar Force Concatenation = Enable

$CCBDT

$CCBFC00

$CCBFC01

Datalogic Gryphon 2D Series Product Reference Guide

Other manuals for Datalogic Gryphon 2D Series