RS-232/USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide 49
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"ACK Character" on
page 276 for more detailed programming instructions.
NOTE
Select ACK Character Setting
DEFAULT
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation
of these characters. 8-bit data is
not recognized when the option
Data Bits on page 42
has been set as 7
Data Bits.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"NAK Character" on
page 277 for more detailed programming instructions.
NOTE
Select NAK Character Setting
DEFAULT
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of th
ese characters. 8-bit data is not
recognized when the option
Data Bits on page 42
has been set as 7 Data
Bits.
To Next Page
Loading...
Need help?
General
