Datalogic QuickScan Lite QW2400 User Manual

Enter/Exit Programming Mode Code 39
142 QuickScan™ Lite QW2400
Code 39 Set Length 2
This feature specifies one of the bar code lengths for Code 39 Length Control
on page 140. Length 2 is the maximum label length if in Variable Length on
page 140 Mode, or the second fixed length if in Fixed Length on
page 140
Mode. Length includes the bar code’s chec
k, data, and full-ASCII shift charac-
ters. The length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ig
nore this length (only one fixed length). See "Set Length 2" on
page 259 for
more detailed programming instructions.
$CC3L2
Select Code 39 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters

Datalogic QuickScan Lite QW2400 Specifications

General

Brand	Datalogic
Model	QuickScan Lite QW2400
Category	Barcode Reader
Language	English