Product Reference Guide
271
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for feature descriptions and programming bar codes for each
parameter. A column has also been provided for recording of your preferred default settings for
these same configurable features.
Table 22. Standard Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 19
USB Suspend Mode
Disable 20
RS-232 ONLY
Baud Rate
9600 21
Data Bits
8 Data Bits 22
Stop Bits
1 Stop Bit 23
Parity
None 23
Handshaking Control
RTS 24
RS-232/USB-COM
Intercharacter Delay
No Delay 26
Beep On ASCII BEL
Disable 27
Beep On Not on File
Enable 27
ACK NAK Options
Disable 28
ACK Character
‘ACK’ 29
NAK Character
‘NAK’ 29
ACK NAK Timeout Value
200 ms 30
ACK NAK Retry Count
3 Retries 31
ACK NAK Error Handling
Ignore Errors Detected 32
Indicate Transmission Failure
Enable 33
Disable Character
‘D’ 33
To Next Page
Loading...
Need help?
General
