1D Symbologies Enter/Exit Programming Mode
Product Reference Guide
181
Industrial 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for Industrial 2 of 5 Length
Control on page 180. Length 1 is the minimum label length if in Variable Length
on page 140 Mode, or the first fixed length if in Fixed Length on page 140
Mode. Length includes the bar code’s da
ta characters only.
The length can be set from 1 to 50 characters. See "Set Length 1" on page 257
for more detailed programming instructions.
$CU2L1
Select Industrial 2 of 5 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
01 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General
