Datalogic QuickScan Lite QW2400 User Manual

1D Symbologies Enter/Exit Programming Mode
Product Reference Guide 167
Codabar Set Length 1
This feature specifies one of the bar code lengths for Codabar Length Control
on page 166. Length 1 is the minimum label length if in Variable Length on
page 166 Mode, or the first fixed length if in Fixed Length on page 166 Mode.
Length includes the bar code’s start, stop, ch
eck and data characters. The
length must include at least one data character.
The length can be set from 3 to 50 characters. See "Set Length 1" on page 257
for more detailed programming instructions.
$CCBL1
Select Codabar Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
03 = Length 1 is 3 Characters

Datalogic QuickScan Lite QW2400 Specifications

General

IP Rating	IP42
Connectivity	Wired
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Light Source	Red LED
Interface	USB, RS-232
Drop Resistance	1.5 m / 5 ft
Reading Range	Up to 30 cm / 11.8 in (depending on barcode density)
Dimensions	6.7 x 2.8 x 2.6 in
Print Contrast Ratio	25%
Decode Capability	1D, 2D codes
Resolution	4 mils
Depth of Field	5 - 30 cm (depending on barcode density and type)
Power Supply	5 VDC
Humidity	5 to 95% (Non-condensing)