Datalogic QuickScan Lite QW2400 User Manual

Enter/Exit Programming Mode Standard 2 of 5
178 QuickScan™ Lite QW2400
Standard 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for Standard 2 of 5 Length
Control on page 176. Length 2 is the maximum label length if in Variable
Length on page 176 Mode, or the second fixed l
ength if in Fixed Length on
page 176 Mode. Length includes the bar code’s check and
data characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See "Set Length 2" on
page 259 for
more detailed programming instructions.
$CS2L2
Select Standard 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters

Datalogic QuickScan Lite QW2400 Specifications

General

Brand	Datalogic
Model	QuickScan Lite QW2400
Category	Barcode Reader
Language	English