Setup
8 QuickScan™ Lite QW2400
Stand Installation
Hands-Free Stand
An accessory is available which holds the reader at a convenient angle, allowing
hands free scanning of items. Press in on the release buttons on both sides of
the stand to raise the arm of the stand as shown in
Figure 4
. The stand can
optionally be attached to a counter or table using
self-tapping screws or dou-
ble-sided tape.
Figure 4. Adjusting the Stand Arm
The holder cup can be positioned in any of the three angles shown in
Figure 5
.
Grasp the holder cup as indicated and ro
tate to the desired position.
Refer to
Scan Mode on page 93
or information about programming the reader for
use with the stand.
Figure 5. Adjusting the Stand
This accessory can also be used as a holder to mount the reader on a wall or
other vertical position as shown in
Figure 6
.
Figure 6. Using the Wall Holder
To Next Page
Loading...
