Datalogic QuickScan Lite QW2400 User Manual

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 97
Pick Mode
Specifies the ability of the reader to decode labels only when they are close to
the center of the aiming pattern. This allows the reader to accurately target
labels when they are placed close together, such as on a pick sheet.
The Pick Mode can be enabl
ed only in Trigger Single Scan Mode. So, when the
trigger is pulled the aiming pattern immediately appears allowing the user to
point the barcode. After a while the reader's illumination starts and the reader
can decode the aimed label.
NOTE
This feature is not compatible with M
ultiple Labels Reading in a Volume.
Pick Mode = Disable
Pick Mode = Enable
DEFAULT
$CSNPM00(CR)
$CSNPM01(CR)

Datalogic QuickScan Lite QW2400 Specifications

General

IP Rating	IP42
Connectivity	Wired
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Light Source	Red LED
Interface	USB, RS-232
Drop Resistance	1.5 m / 5 ft
Reading Range	Up to 30 cm / 11.8 in (depending on barcode density)
Dimensions	6.7 x 2.8 x 2.6 in
Print Contrast Ratio	25%
Decode Capability	1D, 2D codes
Resolution	4 mils
Depth of Field	5 - 30 cm (depending on barcode density and type)
Power Supply	5 VDC
Humidity	5 to 95% (Non-condensing)