Enter/Exit Programming Mode Industrial 2 of 5
182 QuickScan™ Lite QW2400
Industrial 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for Industrial 2 of 5 Length
Control on page 180. Length 2 is the maximum label length if in Variable
Length on page 140 Mode, or the second fixed l
ength if in Fixed Length on
page 140 Mode. Length includes the bar code’s check, data
, and full-ASCII shift
characters. The length does not include start/stop
characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ig
nore this length (only one fixed length). See "Set Length 2" on
page 259 for
more detailed programming instructions.
$CU2L2
Select Industrial 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
To Next Page
Loading...
Need help?
General
