Datalogic QuickScan Lite QW2400 User Manual

Enter/Exit Programming Mode Interleaved 2 of 5 (I 2 of 5)
156 QuickScan™ Lite QW2400
I 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for I 2 of 5 Length Control on
page 154. Length 2 is the maximum label length if in Variable Length on page
159 Mode, or the second fixed le
ngth if in Fixed Length on page 159 Mode. The
length includes the bar code’s check
and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore
this length (only one fixed length). See "Set Length 2" on page 259 for more
detailed programming instructions.
$CI2L2
Select I 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters

Datalogic QuickScan Lite QW2400 Specifications

General

Brand	Datalogic
Model	QuickScan Lite QW2400
Category	Barcode Reader
Language	English