Datalogic QuickScan Lite QW2400 User Manual

Enter/Exit Programming Mode MSI
190 QuickScan™ Lite QW2400
MSI Set Length 2
This feature specifies one of the bar code lengths for MSI Length Control on
page 188. Length 2 is the maximum label length if in Variable Length on page
188 Mode, or the second fixed length if in Fixed Length on page 188 Mode.
Length includes the bar code’s check, data, an
d full-ASCII shift characters. The
length does not include start/stop characters.
The length can be set from 1 to 50 characte
rs. A setting of 0 specifies to ignore
this length (only one fixed length). See "Set Length 2" on page 259 for more
detailed programming instructions.
$CMSL2
Select MSI Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters

Datalogic QuickScan Lite QW2400 Specifications

General

Brand	Datalogic
Model	QuickScan Lite QW2400
Category	Barcode Reader
Language	English