7.1.3 EDITING A PARAMETER
NOTE: Pressing and holding the Menu Navigation buttons provides the auto-repeat
functionality. Values can be changed quickly by holding the navigation buttons for a
prolonged period of time.
• Press the Right or Left buttons to cycle to the section to view/change.
• Press the Up or Down buttons to select the parameter to view/change within the currently
selected section.
• To edit the parameter, press the Tick button to enter edit mode. The parameter begins to
flash to indicate editing.
• Press the Up or Down buttons to change the parameter to the required value.
• Press the Tick button to save the value. The parameter ceases flashing to indicate that it
has been saved.
7.1.4 EXITING THE MAIN CONFIGURATION EDITOR
NOTE: The editor automatically exits after 5 minutes of inactivity to ensure security.
• Press and hold the Stop/Reset Mode button to exit the editor without saving changes.
• Press and hold the Tick button to exit the editor and save the changes.
To Next Page
Loading...
