Deep Sea Electronics Plc DSE8660 MKII

Front Panel Configuration
057-259 ISSUE: 1 Page 126 of 146
7.2.4 EXITING THE ‘RUNNING’ CONFIGURATION EDITOR
NOTE: The editor automatically exits after 5 minutes of inactivity to ensure security.
• Press and hold the Tick button to exit the editor and save the changes.
7.2.5 RUNNING EDITOR PARAMETERS
Section
Parameter as shown on display
Values
Display
Contrast 0 %
Language English, Other
)
Section
Load Parallel Power 0 %
Load Power Factor 0 %
Commissioning Screens Active / Inactive
Voltage Adjust (manual mode only bus available and bus breaker open) 0 %
Frequency Adjust (manual mode only bus available and bus breaker open) 0 %
Auxiliary Mains Fail Out Of Sync Reset Active / Inactive