5. Remove the storage tray.
6. Remove the risers and keep the risers away from the system board tray and no need to disconnect the cables from the PSB.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Remove lower brace cover.
9. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
10. Slide out the system board tray.
11. Make sure to wear gloves for remove sensor tray to prevent hands touch sensor cables directly.
Figure 249.
12. Do not touch the sensor tray cable directly.
13. Release the plunger and rotate the metallic gate to open.
14. Release all the GPU cold plate tubes from the Manifold Liquid cooling module.
Steps
1. Align and insert the sensor tray along the GPU 1 cold plate tubes. Install the sensor tray with tilt angle, make sure the tray is
under the chassis roller and T-pin.
230
Installing and removing system components
To Next Page
Loading...
