Delta Electronics VFD-EL series - B.8.1.3 Power Supply; Lonworks Communication Module

Revision 2016/03, 6ELE, V1.14
B-14
B.8.1.3 Power Supply
No external power is needed. Power is supplied via RS-485 port that is connected to VFD-EL. An 8 pins RJ-
45 cable, which is packed together with this communication module, is used to connect the RS-485 port
between VFD-EL and this communication module for power. This communication module will perform the
function once it is connected. Refer to the following paragraph for LED indications.
B.8.1.4 LEDs Display
1. SP: Green LED means in normal condition, Red LED means abnormal condition.
2. Module: Green blinking LED means no I/O data transmission, Green steady LED means I/O data
transmission OK.
Red LED blinking or steady LED means module communication is abnormal.
3. Network: Green LED means DeviceNet communication is normal, Red LED means abnormal
B.8.2 LonWorks Communication Module (CME-LW01)
B.8.2.1 Introduction
Device CME-LW01 is used for communication interface between Modbus and LonTalk. CME-LW01 needs be
configured via LonWorks network tool first, so that it can perform the function on LonWorks network. No need
to set CME-LW01 address.
This manual provides instructions for the installation and setup for CME-LW01 that is used to communicate
with Delta VFD-EL (firmware version of VFD-EL should conform with CME-LW01 according to the table
below) via LonWorks Network.
B.8.2.2 Dimensions
5
7
.
3
[
2
.
2
6
]
72.2 [2.84]
5
9
.
7
[
2
.
3
5
]
9
.
5
[
0
.
3
7
]
3.5 [0.14]
34.8 [1.37]
SP
CM E-LW01