Delta Electronics VFD-EL series - Page 51

Chapter 4 Parameters|
||
|
4-22 Revision 2016/03, 6ELE, V1.14
Overheat Warning
Applications Purpose Functions
Related
Parameters
Air
conditioner
Safety
measure
When AC motor drive overheats, it uses a thermal sensor to have
overheat warning.
03.00
04.05~04.08
Two-wire/three-wire
Applications Purpose Functions
Related
Parameters
General
application
To run, stop, forward and
reverse by external
terminals
VFD-EL
MI1:("OPEN":STOP)
("CLOSE":FWD)
MI2:("OPEN": STOP)
("CLOSE": REV)
DCM
FWD/STOP
REV/STOP
MI1:("OPEN":STOP)
("CLOSE":RUN)
MI2:("OPEN": FWD)
("CLOSE": REV)
DCM
RUN/STOP
FWD/REV
VFD-EL
3-wire
MI3:("OPEN":STOP)
MI1 ("CLOSE":RUN):
MI2:("OPEN": FWD)
("CLOSE": REV)
DCM
STOP
REV/FWD
RUN
VFD-EL
02.00
02.01
02.09
04.04
Operation Command
Applications Purpose Functions
Related
Parameters
General
application
Selecting the source of
control signal
Selection of AC motor drive control by external
terminals, digital keypad or RS485.
02.01
04.05~04.08
Frequency Hold
Applications Purpose Functions
Related
Parameters
General
application
Acceleration/ deceleration
pause
Hold output frequency during
Acceleration/deceleration
04.05~04.08
Auto Restart after Fault
Applications Purpose Functions
Related
Parameters
Air conditioners, remote
pumps
For continuous and
reliable operation
without operator
intervention
The AC motor drive can be restarted/reset
automatically up to 10 times after a fault
occurs.
08.15~08.16