Chapter 4 Parameters|
||
|
4-42 Revision 2016/03, 6ELE, V1.14
For example: suppose that the frequency source is the first master frequency + second master frequency
command (first master frequency is from keypad and second master frequency is from AVI), user-defined
value 1 is set to 180.0(Pr.00.13 is set to 1800, Pr.00.14 is set to 1).
AVI=2V=180.0/(2V/10V)=36.0, frequency is 36.0/(180.0/60.0)=12.0Hz
Pr.02.18=30.0, frequency is 30.0/(60.0/180.0)=10.0Hz
At this moment, the keypad will display 66.0(36.0+30.0) and the output frequency is 22.0Hz(12.0+10.0). When
reading the value from communication address, the value will be shown as follows: 2102H and 2103H are
22.0Hz, 0212H(Pr.02.18) is 30.0, 0213H(Pr.02.19) is 66.0.
To Next Page
Loading...
