DGSHAPE DWX-42W - Checks Before Milling

12
2. Milling
2. Milling
Checks before Milling ............................................................................................... 13
Usable Workpieces ................................................................................................... 13
Usable Milling Burs ................................................................................................... 13
Preparing Compressed Air (Setting the Regulator) .................................................. 13
Registering Milling Burs ........................................................................................... 14
Registering Milling Burs in VPanel ........................................................................... 14
Enabling Automatic Switching of Milling Burs at the End of Their Service Lives ...... 17
Starting Milling ......................................................................................................... 22
Step 1: Filling the Machine with Coolant .................................................................. 22
Step 2: Setting Milling Burs ...................................................................................... 28
Step 3: Spindle run-in (short) .................................................................................... 29
Step 4: Mounting the workpiece ............................................................................... 30
Step 5: Outputting Milling Data ................................................................................. 32
Checking the Operation Status ................................................................................ 36
Checking the Milling Data Status.............................................................................. 36
Checking the Estimated Milling Time ........................................................................ 37
Checking the Basic Status of the Milling Machine .................................................... 38
Checking the Operation Status of the Milling Machine ............................................. 40
Checking the Milling Bur Usage Status (Replacement Time) ................................... 41
Pausing or Aborting Milling ...................................................................................... 42
Pausing or Aborting Milling ....................................................................................... 42
Deleting Standby Milling Data .................................................................................. 43
Following Daily Operations ...................................................................................... 44
Collet Maintenance, Cleaning of Dummy Pin, and Checking of Coolant Flow Rate...44
Cleaning after Milling Finishes .................................................................................. 51