VPanel Basic Operation
7
1. Basic Operation
MEMO: VPanel serves as resident software.
VPanel works as resident software that is constantly working to manage the milling machine, send emails,* and so on� It is recommended
to congure the settings so that VPanel starts automatically when the computer starts�
Also, clicking in the upper-right corner of the top window will minimize the program to the task tray� The application window
disappears from the display, but the program is not exited� While VPanel is running, is constantly displayed in the task tray�
* Emails are sent to notify the user of milling completion or errors that occur� ("
)
VPanel Display in the Task Tray
When the VPanel icon is displayed in the task tray, the status of the connected milling machine is always monitored� The display
of the VPanel icon changes depending on the status of the milling machine� The meanings of the displays are shown below�
Indicates that at least one of the connected milling machines is on (is online).
Indicates that all the connected milling machines are o.
Indicates that an error has occurred on at least one of the connected milling machines.
If you hover the mouse pointer over this icon, you can check which machine has the error.
Messages are displayed automatically if an error occurs, during milling, and in similar situations.
Even after the message disappears, if you hover the mouse pointer over this icon, the status
of each connected machine (such as Ready, Milling, Finished, Completed, and Oine) will be
displayed. In these situations, perform the maintenance work indicated by the message.
To Next Page
Loading...
