DGSHAPE DWX-42W - 1033-000* the Coolant Has Run out; 1034-0000 the Coolant Tank Is Not Installed

Responding to Error Messages
163
5. Troubleshooting
"1033-000*" The coolant has run out.
Level 1
Situation/Error Cause
• The coolant tank is not lled with the appropriate amount of coolant�
• The coolant lters or coolant lines are clogged�
Procedure
A
Fill the coolant tank with the appropriate amount of coolant.
" 
B
According to the situation, perform the operations shown below.
When the error occurred during milling
Press the operation button on the built-in panel.
Milling will resume.
When the error occurred outside of milling
Hold down the operation button on the built-in panel.
This will clear the error.
If the Error Occurs Again
Perform the operations shown below�
" 
" 
"1034-0000" The coolant tank is not installed.
Level 1
Situation/Error Cause
• The coolant tank has been removed during coolant operation�