DGSHAPE DWX-42W - Other Functions; Milling Bur Change Test

127
4. Useful Functions
Milling bur change test
Check whether the milling bur has been set in the correct position at the correct length�
Procedure
A
Verify the milling bur is set in the ATC magazine.
" 
B
Show VPanel.
" 
C
Select the machine to operate.
D
Click .
E
Click the [Maintenance] tab, and then click [Milling bur change test].
F
Select which milling bur you want to perform the change test for.
The numbers correspond to the ATC magazine numbers. This test checks whether the milling bur set to the selected
number can be held correctly. You can select multiple milling burs.
Other Functions