DGSHAPE DWX-42W - 0000 the Spindle Motor Temperature Is too High; 0000 the Mechanical Part Has Collided

Responding to Error Messages
162
5. Troubleshooting
"102B-0000" The spindle motor temperature is too high.
Level 3
Situation/Error Cause 1
• The milling bur is worn�
• A workpiece that cannot be milled by the machine is being used�
• The milling conditions are too strict�
Procedure
A
Turn o󰀨 the power.
B
Check the milling bur, the workpiece, and the CAM settings as well as the shape specied in the milling
data.
C
Allow the machine to rest for some time before turning the power on.
The motor may have overheated.
Situation/Error Cause 2
• Milling waste has adhered to the spindle�
Procedure
Perform spindle run-in (long).
" 
If the Error Occurs Again
There is a possibility that the spindle unit is defective� To replace the spindle unit, contact your authorized Roland DG Corporation
dealer�
"102E-0000" The mechanical part has collided.
Level 3
Situation/Error Cause
• Operation is inhibited by milling waste or an obstruction�
Procedure
A
Turn o󰀨 the power.
B
Remove any objects blocking operation of the machine and any accumulated milling waste.
C
Turn on the power.