E
Push the coolant tank toward the back of the machine.
Push the coolant tank to the point where you feel a click.
Click
Important
Do not push the tank using the
bottom cover�
Point
Align the label axed to the right side of the tank with the label axed to the machine.
Important
Move the coolant tank slowly� Forcefully moving the coolant tank may cause the coolant to spray out�
F
Close the bottom cover.
This completes the procedure for replacing the coolant.
Care and Storage of the Automatic Correction Jig
The automatic correction jig being damaged, dirty, or rusted will make it impossible to make accurate detections� This may inhibit
the intended milling and may even lead to machine damage�
Care and Storage
• Before use, wipe clean using a dry, clean cloth, and make sure that no dust, rust, or scratches are found�
• When the item will be out of use for a prolonged period, store in a location with low humidity and little uctuation in
temperature�
Periodic Care and Maintenance
67
3. Maintenance
To Next Page
Loading...
