DGSHAPE DWX-42W - 000* the % Milling Bur Might be Broken

Responding to Error Messages
155
5. Troubleshooting
If the Error Occurs Again
• The collet is deformed�
Procedure
A
Replace the collet.
" 
B
Perform automatic correction.
" 
"101E-000*" The % milling bur might be broken.
* The milling bur stocker number (1 to 7) is displayed for %�
Level 2
Situation/Error Cause 1
• The milling bur is broken�
• The milling bur has exceeded its service life�
" 
Procedure
A
Hold down the operation button on the built-in panel.
This will clear the error.
B
Replace the milling bur with a new one.
C
Perform collet maintenance.
" 
Situation/Error Cause 2
• The milling conditions are too strict�
Procedure
A
Hold down the operation button on the built-in panel.
This will clear the error.
B
Review the CAM settings and the shape specied in the CAD data.