DGSHAPE DWX-42W - Starting Milling; Step 1: Filling the Machine with Coolant

22
2. Milling
Starting Milling
Step 1: Filling the Machine with Coolant
CAUTION
Do not overll or tilt the coolant tank.
The uid inlet on the coolant tank is open. Overlling or tilting will cause uid to spill out.
CAUTION
When raising or lowering the coolant tank, hold the position indicated in the following gure.
Failing to do so may result in your ngers being pinched, leading to injury.
Situations Requiring This Work
• When rst using the machine�
• When the uid level in the tank reaches the lower limit�
Lower
limit
* When the usage period exceeds a certain length of time, the coolant must be replaced�
" P. 61 "Replacing the Coolant"
Items to Prepare Separately
• Water: Use soft or puried water� Using hard water may have a negative eect on the service life of the milling bur and on
the quality of the product�
• Additive (ZAW-1000D): You will need to prepare the designated additive separately� To purchase this item, contact your
authorized Roland DG Corporation dealer�
• Chelating reagent (ZCH-100D): You will need to prepare the designated additive separately� To purchase this item, contact
your authorized Roland DG Corporation dealer�
Handling Additives
• Store additives in a cool, dark place�
• Due to the characteristics of the internal components, the color may change and deposits of separated components may
form, but these do not indicate any problems with the use of the additives�
• If component deposits form, lightly shake the container to mix the components before use�