DGSHAPE DWX-42W - Machine Problems

133
5. Troubleshooting
5. Troubleshooting
Machine Problems ................................................................................................. 134
The Machine Does Not Run/Cannot Generate Output ........................................... 134
The Operation Button Does Not Respond .............................................................. 134
VPanel Does Not Recognize the Machine ............................................................. 134
The Machine Recognized by VPanel Is Displayed as OFFLINE ............................ 134
The Computer Shuts Down When Connecting Multiple Machines ......................... 135
Compressed Air Does Not Come Out ..................................................................... 135
Automatic Correction Fails ..................................................................................... 136
Collet Maintenance Cannot Continue Due to an Error Occurring........................... 136
Milling Quality Problems ........................................................................................ 137
The Milling Results Are Not Attractive ....................................................................137
There Is a Line of Level Di󰀨erence in the Milling Results ....................................... 137
The Dimensions of the Milling Results Do Not Match ............................................ 137
Chipping Occurs (Edges of Milling Products Become Chipped) ............................ 138
A Hole Opens in the Milling Results ....................................................................... 138
Installation Problems .............................................................................................. 139
Installing the Driver Separately (USB Connection)................................................. 139
Installing the Driver Separately (LAN Connection) ................................................. 141
Installing the Software and the Electronic-format Manual Separately .................... 141
Driver Installation Is Impossible .............................................................................. 142
Uninstalling the Driver ............................................................................................ 146
Uninstalling VPanel ................................................................................................ 149
Cannot Connect via LAN (Resetting the Machine IP Address) .............................. 150
Responding to Error Messages ............................................................................. 151
Error Message List ................................................................................................. 151
"1000-****" The % limit switch was not found. ........................................................ 152
"1006-02**" The % axis position has been shifted. ................................................ 152
"101C-0000" The milling bur sensor was not found. .............................................. 153
"101D-000*" The % milling bur cannot be released. .............................................. 153
"101D-010*" The % milling bur cannot be released. It might be broken from the root. ...154
"101E-000*" The % milling bur might be broken. ................................................... 155
"101F-000*" The % milling bur chucking has slipped out. ...................................... 156
"1020/1021-000*" The % milling bur is too long/too short. ..................................... 157
"1022-000*" The % milling bur was not found. ....................................................... 158
"1023-0000 to 1028-0000" Milling data error. ......................................................... 159
"1029-0000" The spindle experienced an overload. ............................................... 160
"102A-000*" The spindle experienced overcurrent. ................................................ 161
"102B-0000" The spindle motor temperature is too high. ....................................... 162
"102E-0000" The mechanical part has collided. ..................................................... 162
"1033-000*" The coolant has run out. ..................................................................... 163
"1034-0000" The coolant tank is not installed. ....................................................... 163
"1038-0000" Milling data error. No milling bur is selected. ..................................... 165
"103A-000*" DANGER!! The coolant is leaking!! .................................................... 165
"103B-0000" The automatic correction is not yet nished. ..................................... 166
"103D-0000" Milling data error. The milling bur cannot reach the milling position. .. 166
"105E-0000" The pressure of the compressed air is too high or low. ..................... 167
"****-****" An unknown error occurred. ................................................................... 167