DGSHAPE DWX-42W - 0000 the Milling Bur Sensor was Not Found; 000* the % Milling Bur Cannot be Released

Responding to Error Messages
153
5. Troubleshooting
"101C-0000" The milling bur sensor was not found.
Level 3
Situation/Error Cause
• Operation is inhibited by milling waste or an obstruction in the vicinity of the milling bur sensor�
Procedure
A
Turn o󰀨 the power.
B
Remove any objects blocking operation of the machine and any accumulated milling waste in the
vicinity of the milling bur sensor.
C
Turn on the power, and then resume operation.
"101D-000*" The % milling bur cannot be released.
* The milling bur stocker number (1 to 7) is displayed for %�
Level 2
Situation/Error Cause 1
• The ATC magazine is dirty�
• The inside of the collet is dirty�
Procedure
A
Follow the instructions in the VPanel window to open the collet and remove the milling bur.
B
Clean the ATC magazine.
" 
C
Perform collet maintenance.
" 
Situation/Error Cause 2
• The stocker is out of position�
Procedure
A
Follow the instructions in the VPanel window to open the collet and remove the milling bur.
B
Perform automatic correction.
" 