DGSHAPE DWX-42W - Pausing or Aborting Milling

42
2. Milling
Pausing or Aborting Milling
Aborting Milling from VPanel
Procedure
A
Select the machine to operate.
B
Click .
The message shown in the gure will be displayed.
C
To abort milling, click [OK]. Click [Cancel] to not abort the operation.
Pausing or Aborting Milling from the Built-in Panel
• Pausing: Press the operation button on the built-in panel.
• Resuming: With operation paused, press the operation button on the built-in panel.
• Aborting: Hold down the operation panel on the built-in panel for 2 seconds or longer.
Operation button
Pausing or Aborting Milling