13
2. Milling
Checks before Milling
CAUTION
Securely fasten the milling tool and workpiece in place. After securing in place, make sure no spanners
or other articles have been left behind inadvertently.
Otherwise, such articles may be thrown from the machine with force, posing a risk of injury.
CAUTION
Under no circumstances should you move the Z-axis unit with your hands.
Doing so may cause a breakdown.
Usable Workpieces
Workpiece Materials
• Glass ceramics
• Composite resins
Types and Sizes of Workpieces
• Type: Type with pin
• Maximum number of mountable workpieces: 3
• Maximum size of mountable workpieces: 40 (W) × 20 (D) × 20 (H) mm
* However, the workpiece size is limited by the number of workpieces mounted in the machine, and the number of
mountable workpieces is limited by the size of the workpieces mounted in the machine�
ø5.9 ± 0.02
Pin diameter: 6 mm
Usable Milling Burs
• Dedicated milling bur
Preparing Compressed Air (Setting the Regulator)
Recommended Set Pressure
• 0�18 MPa to 0�22 MPa
To Next Page
Loading...
